We use a DVD for several applications. We can watch a movie in it or play your favorite video games. The DVDs may not function well if it becomes dirty. It has a tendency to skip when it becomes too dirty. It will also have a hard time reading the information properly. The dirt becomes a hindrance for reading the data. Cleaning the DVD is not so hard as long as you follow the right steps accordingly. This is moderately difficult task. The things you will need are duster, cleaning disc, alcohol, q-tips, screw driver and three in one oil.

1. The first step on how to clean a DVD is unplugging it properly. You should make sure that it's completely connected. You should then put it in another place where you would get a lot of room for cleaning it.

2. The second step on how to clean a DVD is examining the player. Check the vents and the fans. You must check if there is a thick build up of the dirt or grime. If the area with the vents already has a big accumulation then it means that you have not cleaned it for a very long time. It would not help if you use the duster on it because it will just get blown back to the player. If the accumulated dust is just light then you should start cleaning it by just blowing on it. There are some DVD players that let you open it up so you can blow on it easily.

3. The third step on how to clean a DVD is putting the disc for cleaning it. You can just watch as it does its job. For a large accumulation of dust or dirt it may not play properly. However if the disc for cleaning finished until the end then you can end your cleaning process

4. The fourth step on how to clean a DVD is disassembling the DVD. This will enable you to clean and remove the large build up of dirt properly. You should start this by looking for the player's seams, security tape and screws. Be careful of the tape because if that breaks then you will not be able to avail your warranty in case it breaks down. You can risk this and open the player. You do this by first removing the screws which you will find on the player's bottom. You should just be taking the casing out then remove the dust accumulation on the vents first by using your duster. Be careful not to shake it because the nitrogen might leak out and damage the player.

5. The fifth step on how to clean a DVD is putting alcohol on your q-tips. Then swipe it on the part with the laser. You can then rub it on the rails if you find any dust on it. Do not swipe the alcohol on the circuits.

6. The sixth step on how to clean a DVD is letting it dry properly. You start by dipping a q-tip with the oil and brushing it on the rails. Then after a few minutes of drying you can close it now and then play the disc for cleaning the player. Then if it plays all the way to the end then you have successfully cleaned your DVD.



Article Source: http://EzineArticles.com/?expert=Brian_Jones_Jr.